Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 5B: R8csi R8r (2 C-LANs)
R8si
3 C-LAN Administration
Switch 1 Task — Assign Link via ppp Data Module to C-LAN(b)
This task administers a ppp data module on Switch 1 for the ppp connection from the
C-LAN(a) circuit pack to the C-LAN(b) circuit pack.
Steps
Begin
> Open Data Module form — enter ad da 2013
add data-module 2013
DATA MODULE
Page 1 of x
Data Extension: 2013 Name: _ppp on link 12 to clan(b)__ BCC: 2
Type: ppp COS: 1
Port: 01c0713 COR: 1
Link: 12 TN: 1
Enable Link? n
Node Name: node-1a _____
Subnet Mask: 255.255.255.0
Establish Connection: y
DESTINATION
Digits: 2378___________
Node Name: node-1b___________
CHAP? n
> Enter values
Field
Type:
Port:
Link:
Enable Link?
Name:
BCC:
Conditions/Comments
This indicates the data-module type for this link.
In this example, the C-LAN(a) circuit pack is in slot
01a07; the ppp connection is through port 13.
The link number must be in the range 1 – 33 (for R8r), not
previously assigned on this switch.
If you need to add an IP route that uses this node as a
gateway, this field must be set to y before adding the IP
route. Otherwise leave this field set to n until the link
administration is complete; that is, until after all data
modules and the processor channels are assigned, then set
to y.
Information-only; appears in list generated by the “list
data module” command.
Bearer Capability Class. This is a display-only field.
1 of 2
182
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000