Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 3: R8si R8r Gateway
R8si
3 C-LAN Administration
Switch 2 Task — Assign Link via procr-intf Data Module to Switch 1
This task administers a processor-interface data module for the x.25 connection to
node 1. The data module associates a link number with a physical channel number
and extension number for the PI port used for this connection.
Steps
Begin
> Open Data Module form — enter a da n
add data-module next
Page 1 of 1
DATA MODULE
Data Extension: 4121
Name: _x.25 on link 2 to node-1__
Type: procr-intf COS: 1 Maintenance Extension: 4191
Physical Channel: 02_ COR: 1 Destination Number: 8122102
ITC: Restricted TN: 1 Establish Connection? n
Link: 2_ DTE/DCE: dce Connected Data Module: _______
Enable Link: n
ABBREVIATED DIALING
List1: _______________
SPECIAL DIALING OPTION: ________________
ASSIGNED MEMBER (Station with a data extension button for this data module)
1.
Ext
Name
> Enter values.
Field
Type:
Physical Channel:
ITC:
Link:
Name:
COS:
COR:
TN:
DTE/DCE:
Conditions/Comments
This indicates the data-module type for this
connection.
This must be the same as the link number.
Enter restricted. (unrestricted is used only for
wideband transmission.)
The link number must be in the range 1 –25 (for
R8si), not previously assigned on this switch.
Information-only; appears in list generated by the “list
data module” command.
The values for these fields will be specified by the
system administrator.
The DTE/DCE assignments must be opposites on the
two ends of the connection. Use dte for node 1.
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
113