Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

QSIG
B Private Networking
3 Enter display system-parameters customer-options on the command line
of your system administration screen.
4 On page 1, verify fields as follows:
~ G3 Version field is V8 or later.
5 If the system is using ATM for QSIG, go to page 2 and verify the following field:
~ Async. Transfer Mode (ATM) Trunking field is y.
6 On page 3, verify fields as follows:
If the system is using ISDN-BRI for QSIG:
~ ISDN-BRI Trunks field is y.
If the system is using ISDN-PRI for QSIG:
~ ISDN-PRI field is y.
If the system is using QSIG Supplementary Services with or without Rerouting:
~ Restrict Call Forward Off Net field is n.
7 On page 4, verify fields as follows:
~ Basic Call Setup field is y.
If the system is using QSIG Supplementary Services:
~ Basic Supplementary Services field is y.
If the system is using QSIG Supplementary Services with Rerouting:
~ Supplementary Services with Rerouting field is y.
If the system is using QSIG VALU:
~ Value-Added Lucent (VALU) field is y.
8 (For ISDN-PRI only). Administer or check the QSIG DS-1 circuit pack (see
Appendix A). Check for the following field entries:
• Connect field - pbx
• Interface - peer-master or peer-slave
• Peer protocol - q-sig
• Signaling mode - isdn-pri or isdn-ext
• Channel Numbering - sequential or timeslot (This item must match
between the local switch and receiving switch.)
9 (For ISDN-BRI only). Administer or check the QSIG ISDN-BRI circuit pack (see
Appendix A).
372
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000