Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 5B: R8csi R8r (2 C-LANs)
R8si
3 C-LAN Administration
> Submit the screen
End
Field
Session -
Local
Session -
Remote
Mach ID
The Local and Remote Session numbers can be any value
between 1 and 256 (si model) or 384 (r model), but they must be
consistent between endpoints. For each connection, the Local
Session number on this switch must equal the Remote Session
number on the remote switch and vice versa.
It is allowed, and sometimes convenient, to use the same number
for the Local and Remote Session numbers.
Destination switch ID identified on the dial plan of the
destination switch.
For Processor Channel 32: (connection to Switch 2 through Switch 1)
Enable Set to y.
Appl. Set to dcs for DCS signaling.
Mode Node-3 is the "server". Set node-2 to "client" (c).
Interface Link This must match the link number assigned on the node-3 data
module screen.
Interface
Chan
Destination
Node
Destination
Port
Session -
Local
Session -
Remote
Mach ID
Conditions/Comments
For TCP/IP, interface channel numbers are in the range 5000 –
64500. This number must match the Destination Port number on
the Switch-3 Processor Channel screen.
Name of the far-end node for this channel. This must be a name
entered on the Node Names screen.
For TCP/IP, interface channel numbers are in the range 5000 –
64500.
The recommended values are: 5001 for CMS, 5002 for Intuity
AUDIX, and 5003 for DCS connections that are not gateways.
These three values should be reused for multiple instances of
these applications. The combination of Link, Interface Channel,
and Mach ID must be unique.
This number must match the Destination Port number on the
Switch-2 Processor Channel screen.
For each connection, the Local Session number on this switch
must equal the Remote Session number on the remote switch and
vice versa.
Destination switch ID identified on the dial plan of the
destination switch.
2 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
201