Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

IP Trunk Administration
F IP Trunk Installation and
Administration
NT Tasks
• Log on to Windows NT and start the IP Trunk service
• Use the Configuration Manager to administer the routes and dialing permissions
you defined on the Dial/Routing Plan worksheets or the procedures for extension
dialing between sites.
• Use the Configuration Manager to set the IP Trunk service parameters
Plan call routing
Use the IP Trunk worksheets (shown at the end of this appendix) and/or the
Procedures for Extension Dialing Between Sites to plan and coordinate your IP Trunk
administration in Configuration Manager and DEFINITY ECS switch administration
software.
You will create a dialing and routing plan, then use the information to administer
DEFINITY ECS and the IP Trunk application. Read and follow these instructions
carefully.
Using the Procedures
for Extension Dialing
Between Sites
Using the Dial/Routing
Plan Worksheets
Follow these procedures for administering extension dialing between several sites.
This section includes the steps for administration as well as examples using three sites
that show DCS and non-DCS scenarios.
The worksheets are used for any two-site configuration allowing off-premise dialing.
Worksheet 1 is used to capture general information about your site.
Worksheets 2–8 are used for different levels of off-premise dialing restrictions at the
remote site, as listed in the following table.
Off-Premise Dialing at Remote Site:
Worksheet 2: No off-premise dialing at remote site.
Worksheet 3: any exchange
Same Area Code
Worksheet 4: only exchange X
Worksheet 5: any area code
Same Country
Worksheet 6: only area code X
Worksheet 7: any different country
Worksheet 8: only different country X
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
419