Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 5B: R8csi R8r (2 C-LANs)
R8si
3 C-LAN Administration
Switch 2 Task — Assign Link via ppp Data Module to Switch 1
This task administers a ppp data module on Switch 2 for the ppp connection to Switch
1. The data module associates a link number with a port address, extension number,
and node name for the C-LAN port used for this connection.
Steps
Begin
> Open Data Module form — enter ad da 3020
add data-module 3020
DATA MODULE
Page 1 of x
Data Extension: 3020 Name: _ppp on link 1 to node-1a-ppp BCC: 2
Type: ppp COS: 1
Port: 01a0413 COR: 1
Link: 1_ TN: 1
Enable Link? n
Node Name: node-2___ _
Subnet Mask: 255.255.255.0
Establish Connection: n
DESTINATION
Digits: __________
Node Name: node-1a-ppp______
CHAP? n
> Enter values
Field
Type:
Port:
Link:
Enable Link?
Name:
BCC:
Conditions/Comments
This indicates the data-module type for this connection.
In this example, the C-LAN circuit pack is in slot 01a04; the ppp
connection is through port 13.
The link number must be in the range 1 – 25 (for R8csi), not
previously assigned on this switch
If you need to add an IP route that uses this node as a gateway,
this field must be set to y before adding the IP route. Otherwise
leave this field set to n until the link administration is complete;
that is, until after all data modules and the processor channels
are assigned, then set to y.
Information-only; appears in list generated by the “list data
module” command.
Bearer Capability Class. This is a display-only field.
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
191