Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 3: R8si R8r Gateway
R8si
3 C-LAN Administration
> Submit the screen
End
Field
Name:
COS:
COR:
TN:
DTE/DCE:
Enable Link?
Remote
Loop-Around
Test?
Destination
Number:
Establish
Connection?
Connected
Data Module
Error Logging?
Permanent
Virtual Circuit?
Switched
Virtual Circuit?
Highest PVC
Logical
Channel:
Conditions/Comments
Information-only; appears in list generated by the “list data
module” command.
The values for these fields will be specified by the system
administrator.
The DTE/DCE assignments must be opposites on the two ends
of the connection. Use dce for node 2.
Set to y after the processor channels have been assigned.
Set to n unless testing.
external is used when connecting an r-model to an si-model.
For an r-to-r connection, enter the TAC+extension.
y means that this switch will be responsible for the call setup
for this connection. Enter n when administering the data
module for Switch 2.
Extension of node-2 data module.
Set to n for normal operations.
Set to y for testing — logs all data module errors.
Always y for DCS, CMS, and Intuity AUDIX.
Always n for DCS, CMS, and Intuity AUDIX.
Set to 64 (the default) for normal operations.
2 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
105