Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 1: R8r R8si
3 C-LAN Administration
Switch 2 Task — Assign Link via ppp Data Module to Switch 1
This task administers a ppp data module on Switch 2 for the ppp connection to Switch
1. The data module defines a network interface — it associates a link number with a
port address and node name for the C-LAN port on Switch 2. It also specifies the
node name for the destination node, which is a C-LAN port on Switch 1.
Steps
Begin
>Open Data Module form — enter ad da n
add data-module next
DATA MODULE
Page 1 of x
Data Extension: 3020 Name: _ppp on link 3 to node-1___ BCC: 2
Type: ppp COS: 1
Port: 01a1206 COR: 1
Link: 3_ TN: 1
Enable Link? n
Node Name: node-2_ ____
Subnet Mask: 255.255.255.0
Establish Connection: n
DESTINATION
Digits: __________
Node Name: node-1_________
CHAP? n
[This data module is assigned the next available extension, 3020.]
>Enter values
Field
Type:
Port:
Link:
Enable Link?
Name:
Conditions/Comments
This indicates the data-module type for this link.
In this example, the C-LAN circuit pack is in slot 01a12; the ppp
connection is through port 06.
The link number must be in the range 1 – 25, not previously
assigned on this switch.
If you need to add an IP route that uses this node as a gateway,
this field must be set to y before adding the IP route. Otherwise
leave this field set to n until the link administration is complete;
that is, until after all data modules and the processor channels
are assigned, then set to y.
Information-only; appears in list generated by the “list data
module” command.
1 of 2
68
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000