Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

IP Trunk Administration
F IP Trunk Installation and
Administration
DEFINITY administration procedures
The following procedures must be performed on the DEFINITY ECS to administer IP
Trunks.
! CAUTION:
The fields described in the following procedure must be completed as shown.
If they are not, the IP Trunk service may not work properly. Other fields may
be completed as appropriate for your system.
DS1 Circuit Pack
As an example, administer the IP Trunk circuit pack at 01A09 to emulate T1 service
for 24 channels. (See the table below for the settings to emulate E1 service for 30
channels). Note that you are administering the IP Trunk circuit pack in this procedure,
not an actual DS1 circuit pack.
1 Type add ds1 01A09 and press ENTER.
01A09 is the address of the IP Trunk circuit pack. The DS1 Circuit Pack screen
appears.
add ds1 1a09
DS1 CIRCUIT PACK
Location: 01A09
Bit Rate: 1.544
Line Compensation: 3
Signaling Mode: robbed-bit
Name: T1-RB to ITS1
Line Coding: ami-zcs
Framing Mode: d4
Interface Companding: mulaw
Idle Code: 11111111
MAINTENANCE PARAMETERS
Slip Detection? n
2 Enter the field values as shown in the screen diagram above.
3 Press ENTER to save your changes.
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
421