Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 3: R8si R8r Gateway
R8si
3 C-LAN Administration
Switch 1 Task — Assign Processor Channels
This task associates data links (hardware) with processor channels (software) on the
node-1 switch.
Steps>
Begin
> Open Processor Channel Assignment form — enter ch com p
change communications-interface processor-channels
PROCESSOR CHANNEL ASSIGNMENT
Page 1 of X
Proc Gtwy Interface Destination Session Mach
Chan Enable Appl. To Mode Link/Chan Node Port Local/Remote ID
1: n ________ _ __ _____ _________ 0____ ___ ___ __
2: n ________ _ __ _____ _________ 0____ ___ ___ __
:
21: y dcs_____ _ 5_ 21___ _________ 0____ 21_ 21_ 2_
:
23: y gtwy-tcp 32_ _ 5_ 23___ _________ 0____ 23_ 23_ __
:
31: y dcs_____ s 3_ 5003 node-3___ 0_ 31_ 31_ 3_
:
32: y gtwy-tcp 23_ s 3_ 6002 node-3___ 0 _ 32_ 32_ __
:
256: n ________ _ __ _____ _________ 0____ ___ ___ __
Note: The Processor Channel number, the Interface Channel number, and the
Local and Remote Session numbers do not need to be the same number
but they should be made the same whenever possible to simplify network
“bookkeeping” and diagnostics.
> Enter values
Field
Conditions/Comments
Processor Channel 21: (X.25 connection to Switch 2)
Enable Set to y.
Appl.
Set to dcs for DCS signaling.
Mode
Used for TCP/IP connections only.
Interface Link This must match the link number assigned on the x.25 data
module screen.
Interface Chan The interface channel number must be in the range 1 – 64 for
an X.25 link.
Destination Node Used for TCP/IP connections only.
Destination Port Used for TCP/IP connections only.
1 of 4
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
109