04.11.2014 Views

Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

IP Trunk <strong>Admin</strong>istration<br />

F IP Trunk Installation and<br />

<strong>Admin</strong>istration<br />

For any two-site configuration, you would fill out Worksheet 1 and one of the<br />

worksheets 2–8. Use the worksheets as follows:<br />

1 Fill out the general in<strong>for</strong>mation about your sites using Worksheet 1.<br />

The Field Codes on Worksheet 1 consist of a number (1 or 2) that indicates the<br />

site, and a letter (A–J) that indicates a field on an administration screen. For each<br />

code, the Field Value column holds the specific value <strong>for</strong> that field <strong>for</strong> your<br />

switches. The field codes are used on all the other worksheets to indicate the<br />

values to enter from Worksheet 1.<br />

For example, field code 1A corresponds to the field International Access code <strong>for</strong><br />

site 1. You would enter the value in the Field Value column <strong>for</strong> the International<br />

Access code <strong>for</strong> your site-1 switch. Then, when 1A appears on a subsequent<br />

worksheet, you would enter the value corresponding to 1A from Worksheet 1.<br />

2 Use the second and subsequent worksheets to plan switch and IP Trunk<br />

administration.<br />

On each worksheet, in the Fill in with your actual values column, replace the<br />

indicated field codes with the corresponding values you entered on Worksheet 1.<br />

For example, on Worksheet 2 there is a field called Different Country <strong>for</strong> each<br />

site. Its field code is 1A2B2D2E, which means that you would enter the values<br />

from Worksheet 1 as follows:<br />

<br />

Once you’ve done this, the result is the exact phone number that you’ll enter in<br />

the matching field in the administration software.<br />

Note:<br />

The IP Trunk application only recognizes digits. Don’t use characters<br />

such as ~w, ~p, + and so on in dialed digit <strong>for</strong>mats that will be sent to IP<br />

trunks: the application won’t recognize these characters.<br />

3 Use these worksheets to administer all your sites using IP Trunk. You can permit<br />

a different level of off-premise dialing <strong>for</strong> each site. For example, Site 1 may<br />

allow limited off-premise dialing, but Site 2 may not, and so on.<br />

420<br />

<strong>Admin</strong>istration <strong>for</strong> <strong>Network</strong> <strong>Connectivity</strong><br />

CID: 77730 555-233-504 — Issue 1 — April 2000

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!