Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 5B: R8csi R8r (2 C-LANs)
R8si
3 C-LAN Administration
Switch 3 Task — Assign IP Interfaces
The IP interface for each C-LAN board on the switch must be defined on the IP
Interfaces form. Each DEFINITY switch in an IP network has one IP Interfaces form.
Steps
Begin
> Open IP Interfaces form — enter ch ip-i
change ip-interfaces Page 1 of 2
IP Interfaces
Inter-region IP connectivity allowed? n
Enable
Net
Eth Pt Type Slot Code Sfx Node Name Subnet Mask Gateway Addr Rgn
y C-LAN 01a05 TN799 B node-3 255.255.255.0 192.168.1_ .128 1
n 255.255.255.0
n 255.255.255.0
n 255.255.255.0
> Enter values
Field
Inter-region IP
connectivity
allowed?
Enable Eth Pt
Type
Slot
Code
Sfx
Node name
Conditions/Comments
Enter y to allow IP endpoints (phones and trunks) to use
MedPro resources administered in regions that are
different from the endpoints’ regions.
The Ethernet port must be enabled (y) before it can be
used. The port must be disabled (n) before changes can be
made to its attributes on this screen.
Enter c-lan or medpro.
Enter the slot location for the circuit pack.
Display only. This field is automatically populated with
TN799 for C-LAN or TN802 for MedPro.
Display only. This field is automatically populated with B
for the TN802 and TN799.
Enter the unique node name for the IP interface. The node
name here must already be administered on the Node
Names screen
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
197