Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 2: R7r (+CMS) R7csi
3 C-LAN Administration
Switch 1 Task — Assign IP Interfaces
The IP interface for each C-LAN and MedPro board on the switch must be defined on
the IP Interfaces form. Each DEFINITY switch in an IP network has one IP Interfaces
form.
Steps
Begin
> Open IP Interfaces form — enter ch ip-i
change ip-interfaces Page 1 of 2
IP Interfaces
Inter-region IP connectivity allowed? n
Enable
Net
Eth Pt Type Slot Code Sfx Node Name Subnet Mask Gateway Addr Rgn
y C-LAN 01c08 TN799 B node-1 255.255.255.224 192.168.1_.97_ 1
n 255.255.255.0
n 255.255.255.0
n 255.255.255.0
> Enter values
Field
Inter-region IP
connectivity
allowed?
Enable Eth Pt
Type
Slot
Code
Sfx
Node name
Conditions/Comments
Enter y to allow IP endpoints (phones and trunks) to use MedPro
resources administered in regions that are different from the
endpoints’ regions.
The Ethernet port must be enabled (y) before it can be used. The
port must be disabled (n) before changes can be made to its
attributes on this screen.
Enter c-lan or medpro.
Enter the slot location for the circuit pack.
Display only. This field is automatically populated with TN799
for C-LAN or TN802 for MedPro.
Display only. This field is automatically populated with B for
the TN802 and TN799.
Enter the unique node name for the IP interface. The node name
here must already be administered on the Node Names screen
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
77