Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Networking Screens
A Screens Reference
Appl.
Identifies the switch application used on this link.
Valid entries
audix, dcs, fp-mwi, gateway,
gtwy-tcp, mis, msaamwl,
msaclk, msahlwc, msallwc,
msamcs, qsig-mwi, and blank
Usage
The gateway application is used for conversion
between ISDN and either TCP/IP or BX.25.
The gtwy-tcp application is used for
conversion between BX.25 and TCP/IP.
These application types are used on the
gateway switch only.
Gtwy To
Used for gtwy-tcp applications only. Identifies the processor channel that this
processor channel is serving as a gateway to.
Valid entries
1-128 (csi model)
1-256 (si model)
1-384 (r model)
Usage
Two processor channels on the gateway switch are needed
to set up a gtwy-tcp gateway, which converts between
X.25 and TCP/IP protocols. For each of the two gtwy-tcp
processor channels, the Gtwy To field points to the other
gtwy-tcp processor channel.
For example, if processor channels 5 and 17 are used for a
gtwy-tcp gateway, Gtwy To for processor channel 5
would be set to 17 and Gtwy To for processor channel 17
would be set to 5.
Mode
Identifies whether the IP session is passive (client) or active (server).
Valid
entries
c (client)
s (server)
blank
Usage
This field must be blank if the type of interface link is x.25 (r model)
or procr-intf (si model). This field cannot be blank if the type of
interface link is ethernet or ppp.
Set the Mode to s for ppp or ethernet connections to CMS. Set
opposite values (cs) on the endpoints for ppp or ethernet
connections between switches or between a switch and Intuity
AUDIX.
274
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000