Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 5B: R8csi R8r (2 C-LANs)
R8si
3 C-LAN Administration
Switch 2 Task — Assign Processor Channels
This task associates data links (hardware) with processor channels (software) on
Switch 1.
Steps
Begin
> Open the Processor Channel Assignment form — enter ch com p
change communications-interface processor-channels
PROCESSOR CHANNEL ASSIGNMENT
Page 1 of X
Proc Gtwy Interface Destination Session Mach
Chan Enable Appl. To Mode Link/Chan Node Port Local/Remote ID
1: n _______ _ __ _____ _____________ 0____ ___ ___ __
2: n _______ _ __ _____ _____________ 0____ ___ ___ __
3: n _______ _ __ _____ _____________ 0____ ___ ___ __
4: n _______ _ __ _____ _____________ 0____ ___ ___ __
:
21: y dcs ___ c 1_ 0 _ node-1a-ppp__ 5003_ 21_ 12_ 1_
23: y dcs ___ c 1_ 0 _ node-3_______ 5003_ 23_ 32_ 3_
:
64: n _______ _ __ _____ _____________ 0____ ___ ___ __
> Enter values
Field
Conditions/Comments
For Processor Channel 21: (ppp connection to Switch 1)
Enable Set to y.
Appl.
Set to dcs for DCS signaling.
Mode
Node-2 is the “client” for this session. Set node-1a to
“server” (s).
Interface Link Must match the link number assigned on the node-2 data
module screen.
Interface Chan A value of 0 allows any available interface channel to be
used for this connection. The Destination Port number on
the Switch-1 Processor Channel screen must also be set to
0.
Destination Node Name of the far-end node for this channel. This must be a
name entered on the Node Names screen. For ppp
connections, it must match the Destination Node Name
entered on the ppp Data Module screen.
Destination Port This number must match the Interface Channel number
assigned on the Switch-1 Processor Channel screen.
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
193