Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 4: R8csi R8si Gateway
R8csi
3 C-LAN Administration
Switch 1 Task — Assign Processor Channels
This task associates data links (hardware) with processor channels (software) on the
node 1 switch.
Steps
Begin
> Open the Processor Channel Assignment form — enter ch com p
change communications-interface processor-channels
PROCESSOR CHANNEL ASSIGNMENT
Page 1 of X
Proc Gtwy Interface Destination Session Mach
Chan Enable Appl. To Mode Link/Chan Node Port Local/Remote ID
1: n _______ _ __ _____ __________ 0____ ___ ___ __
2: n _______ _ __ _____ __________ 0____ ___ ___ __
:
13: y dcs ___ s 1_ 5003_ node-3____ 0 13__ 31_ 3_
14: y gateway s 1_ 6002_ node-3____ 0 14__ 32_ __
:
64: n _______ _ __ _____ __________ 0____ ___ ___ __
> Enter values
Field
Conditions/Comments
Processor Channel 13: (ppp connection to Switch 3)
Enable Set to y.
Appl. Set to dcs for DCS signaling.
Mode Node-1 is the “server” for this session. Set node-3 to “client”
(c).
Interface Link This must match the link number assigned on the node-1 data
module screen.
Interface Chan For TCP/IP, interface channel numbers are in the range 5000 –
64500.
The recommended values are: 5001 for CMS, 5002 for Intuity
AUDIX, and 5003 for DCS connections that are not gateways.
These three values should be reused for multiple instances of
these applications; for example, if there are two Intuity
AUDIX’s, use 5002 for both; or if there are four DEFINITY
ECS’s, use 5003 for all four. The combination of Link, Interface
Channel, and Mach ID must be unique.
This number must match the Destination Port number on the
node-3 Processor Channel screen.
1 of 3
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
129