Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 4: R8csi R8si Gateway
R8csi
3 C-LAN Administration
Switch 1 Task — Assign Link via ppp Data Module to Switch 3
This task administers a ppp data module for the ppp connection to node 3. The data
module associates a link number with a port address, extension number, and node
name for the C-LAN port used for this connection.
Steps
Begin
> Open Data Module form — enter ad da 5803
add data-module 5803
DATA MODULE
Page 1 of x
Data Extension: 5803 Name: _ppp on link 1 to node-3___ BCC: 2
Type: ppp COS: 1
Port: 01b1115 COR: 1
Link: 1_ TN: 1
Enable Link? n
Node Name: node-1 _____
Subnet Mask: 255.255.255.0
Establish Connection: y
DESTINATION
Digits: 792801_________
Node Name: node-3_________
CHAP? n
[This data module is assigned the extension 5803; you can assign any unused
extension in the dial plan]
> Enter values
Field
Type:
Port:
Link:
Enable
Link?
Name:
Conditions/Comments
This indicates the data-module type for this connection.
In this example, the C-LAN circuit pack is in slot 01b11; the ppp
connection is through port 15.
The link number must be in the range 1 – 25 (for R8si), not
previously assigned on this switch.
If you need to add an IP route that uses this node as a gateway,
this field must be set to y before adding the IP route. Otherwise
leave this field set to n until the link administration is complete;
that is, until after all data modules and the processor channels are
assigned, then set to y.
Information-only; appears in list generated by the “list data
module” command.
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
127