Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 5B: R8csi R8r (2 C-LANs)
R8si
3 C-LAN Administration
Switch 1 Task — Assign IP Route: C-LAN(b) to node-2
This task specifies a route for packets handled by C-LAN(b) destined for node-2. This
route is needed because node-1b and node-2 are connected via ppp and there are
intermediate nodes between them.
Steps
Begin
> Enable the ppp link on the node-1b data module screen:
ch da 2378, set Enable Link? to y.
> Open the IP Routing form — enter a ip n
add ip-route next Page 1 of 1
IP ROUTING
Route Number: 3
Destination Node: node-2____
Gateway: node-1a
C-LAN Board: 1c08
Metric: 1
[The system assigns the route number 3.]
> Enter values
Field
Destination Node:
Gateway:
C-LAN Board:
Metric:
Conditions/Comments
The name of the node at the destination of this route.
Node name of the gateway by which the destination node
is reached for this route.
The location of the C-LAN circuit pack that provides the
interface for this route.
Enter 1, which indicates a complex route involving two
C-LAN boards.
See IP Routing (page 251) in Appendix A for more
information on the use of the Metric field.
> Submit the screen
End
188
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000