Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

H.323 Trunk Administration
2 H.323 Trunks
Task 4 — Create a signaling group
This task creates a signaling group that will be associated with H.323 trunks that
connect this switch to a far-end switch. One or more unique signaling groups must be
established for each far-end node that this switch is connected to via H.323 trunks.
Note:
The following steps address only those fields that are specifically related
to H.323 trunks. The other fields are administered as for previous releases
and are described in the Administrator’s Guide.
Task 4 Steps
Begin
> Open new Signaling Group form — enter a sig n
add signaling-group n Page 1 of 5
SIGNALING GROUP
Group Number: 3 Group Type: h.323
Trunk Group for Channel Selection:
Supplementary Service Protocol: a
Max number of NCA TSC: 0
Max number of CA TSC: 0
Trunk Group for NCA TSC:
Near-end Node Name: clan-a1 Far-end Node Name: clan-b1
Near-end Listen Port: 1720 Far-end Listen Port: 1720
LRQ Required? n
Calls Share IP Signaling Connection? n
Bypass If IP Threshold Exceeded? n
Internetworking Message: PROGress
> Enter values
Field
Conditions/Comments
Group Type: Enter h.323
Trunk Group for
Channel Selection:
Near-end Node Name:
Leave blank until you create a trunk group in the
following task; then use the change command and enter
the trunk group number in this field.
Enter the node name for the C-LAN IP interface on this
switch. The node name must be administered on the
Node Names screen and the IP Interfaces screen.
Near-end Listen Port: Enter an unused port number from the range 1719, 1720
or 5000–9999. The number 1720 is recommended.
Note:
If the LRQ field is set to y, the near-end
Listen Port must be 1719.
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
43