Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

H.323 Trunk Administration 2 H.323 Trunks
H.323 Trunk Administration — Task Summary
After the enabling administration is complete, you can administer the H.323 IP trunks. The screens and fields
that need to be administered are listed below.
NOTE: This is only a list of screens and the fields that need to be
administered. The values that need to be entered in these fields are
described in the next section.
Node names
IP Interfaces
Ethernet Data Module
A node name and IP address must be entered on the Node Names screen for each
C-LAN and IP Interface board on the local switch. For each far-end node that the
H.323 trunks on the local switch will connect to, a node name and IP address must be
entered for the far-end gatekeeper, which is a C-LAN board if the far-end is a
DEFINITY switch. Enter values in these fields:
~ Node Name
~ IP Address
Each DEFINITY switch in an IP network has one IP Interfaces screen. One line on
this screen must be administered for each C-LAN and each IP Interface board. Enter
values in these fields:
~ Network regions are interconnected?
~ Enable
~ Type
~ Slot
~ Code
~ Sfx
~ Node Name
~ Subnet Mask
~ Default Gateway Address
~ Region
A data module screen, type ethernet, must be administered for each C-LAN board on
the switch. Enter values in these fields:
~ Type
~ Port
~ Link
~ Name
~ Network uses 1’s for broadcast address?
36
Administration for Network Connectivity
CID: 77730 555-233-504 — Issue 1 — April 2000