Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 1: R8r R8si
3 C-LAN Administration
Switch 1 Task — Assign Link via ppp Data Module to Switch 2
This task administers a ppp data module on Switch 1 for the ppp connection to Switch
2. The data module defines a network interface — it associates a link number with a
port address and node name for the C-LAN port on Switch 1. It also specifies the
node name for the destination node, which is a C-LAN port on Switch 2.
Steps
Begin
> Open Data Module form — enter ad da n
add data-module next
DATA MODULE
Page 1 of x
Data Extension: 2010 Name: _ppp on link 1 to node-2___ BCC: 2
Type: ppp COS: 1
Port: 01b0115 COR: 1
Link: 1_ TN: 1
Enable Link? n
Node Name: node-1 _____
Subnet Mask: 255.255.255.0
Establish Connection: y
DESTINATION
Digits: 6113020________
Node Name: node-2_________
CHAP? n
[The system assigns the extension 2010 to this data module. Instead of n (next) in the
command line, you could specify any unused extension in the dial plan.]
> Enter values
Field
Type:
Port:
Link:
Enable Link?
Name:
Conditions/Comments
This indicates the data-module type for this connection (ppp).
In this example, the C-LAN circuit pack is in slot 01b01; the ppp
connection is through port 15.
For G3r, the link number must be in the range 1 – 33, not
previously assigned on this switch.
If you need to add an IP route that uses this node as a gateway,
this field must be set to y before adding the IP route. Otherwise
leave this field set to n until the link administration is complete;
that is, until after all data modules and the processor channels are
assigned, then set to y.
Information-only; appears in list generated by the "list data
module" command.
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
63