Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Networking Screens
A Screens Reference
Data Module - type X.25 (used for BX.25 connections with the r model)
This form applies only to the r model.
DATA MODULE
Page 1 of 2
Data Extension: ____
Name: ____________________
Type: x.25
Remote Loop-Around Test? n
Port: __ COR: 1 Destination Number: ______
Baud Rate: __________ TN: 1 Establish Connection? n
Endpoint Type:_________
Connected Data Module: ____
Link: 1_ DTE/DCE: ___ Error Logging? _
Enable Link? n
Permanent Virtual Circuit? _
Switched Virtual Circuit? _
Highest PVC Logical Channel: __
Common Fields
See Common Data Module Fields (256) for descriptions of fields on this screen that
are not listed below.
Baud Rate
Specifies the data transmission rate for this connection.
Valid entries
Usage
9600, 19200, switched Set to 9600 for DCS connections to the si model, or to
an r model with an external 9600 baud data line.
Set to switched for r-to-r connections with
common-channel signaling on DS1 trunks.
Set to 9600 for connections to Intuity.
Set to either 9600 or 19200 for CMS, depending on
the physical connectivity.
Endpoint Type
Must be assigned as adjunct. An endpoint type is a type of packet switched data
endpoint that uses X.25 call control procedures. The X.25 Endpoint connects to
external ports on the PGATE board and to the TDM bus via a DS1 trunk. Ports
connected to the adjunct endpoint can be either DTEs or DCEs.
Valid entries Usage
adjunct Set to adjunct for DCS, CMS, or Intuity AUDIX.
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
269