Definity ECS Admin for Network Connectivity.pdf - TextFiles.com

Configuration 3: R8si R8r Gateway
R8si
3 C-LAN Administration
Switch 3 Task — Assign Processor Channels
This task associates data links (hardware) with processor channels (software) on
Switch 3.
Steps
Begin
> Open Processor Channel Assignment form — enter ch com p
change communications-interface processor-channels
PROCESSOR CHANNEL ASSIGNMENT
Page 1 of X
Proc Gtwy Interface Destination Session Mach
Chan Enable Appl. To Mode Link/Chan Node Port Local/Remote ID
1: n _______ _ __ _____ ____________ 0____ ___ ___ __
2: n _______ _ __ _____ ____________ 0____ ___ ___ __
:
31: y dcs____ c 3_ 0 _ node-1______ 5003 31_ 31_ 1_
:
32: y dcs____ c 3_ 0 node-1______ 6002 32_ 32_ 2_
:
256: n _______ _ __ _____ ____________ 0____ ___ ___ __
Note: The Processor Channel number, the Interface Channel number, and the
Local and Remote Session numbers do not need to be the same number
but they should be made the same whenever possible to simplify network
“bookkeeping” and diagnostics.
> Enter values
Field
Conditions/Comments
For Processor Channel 31: (ethernet connection to Switch 1)
Enable Set to y.
Appl.
Indicates that this connection will carry DCS data.
Mode
Node-3 is the “client” for this session. Set node-1 to
“server” (s).
Interface Link This must match the link number assigned on the node-3
data module screen.
Interface Chan A value of 0 allows any available interface channel to be
used for this connection. This number must match the
Destination Port number on the Switch-1 Processor
Channel screen.
Destination Node Name of the far-end node for this channel. This must be a
name entered on the Node Names screen.
1 of 2
Administration for Network Connectivity
555-233-504 — Issue 1 — April 2000 CID: 77730
121