EvitaXL

Evita 4 Link (optional)
Evita 4 Link (optional)
In addition to the standard RS 232 interface COM 1, EvitaXL
also has two serial RS 232 interfaces, COM 2 and COM 3,
two CAN interfaces and an analogue interface with two
channels.
On both serial interfaces
COM 2 and COM 3, the following can be output (optional):
— The LUST protocol*,
— the MEDIBUS protocol,
— a printer protocol.
The LUST protocol and printer protocol can only be output on
one serial interface, while the MEDIBUS protocol can be output
simultaneously on both serial interfaces.
Other equipment, e.g. printers, may only be connected to
the COM interfaces if EvitaXL is connected to the mains
power supply via a mains power cable or if it has been
earthed via the earth connection on the back of EvitaXL.
Electric power may pose a hazard in all other cases.
For output of measured values, status messages and alarm
messages to on-line equipment for monitoring, documentation
or processing.
The on-line equipment may be a Dräger device or a device
made by any other manufacturer.
All data transmitted in this way are intended for information
only and must not be used as the sole basis for deciding on a
particular therapy.
The RS 232 interfaces meet the requirements of the standards
"EIA Standard RS 232 C" and "CCITT V.24".
* For a detailed description of the LUST protocol, see "Technical
data, LUST protocol" on page 201.
178 Instructions for Use EvitaXL