EvitaXL

1 Hang the hinged arm from the rail on the left-hand side and
tighten screws.
● Fit the ventilation hoses. Check the hose lengths (metres).
2 Turn ports in direction of hoses.
3 Install water traps in vertical position.
4 Connect the Y-piece, with the rubber sleeve of the Y-piece
on the inspiratory side.
5 Insert the Y-piece in the opening of the hinged arm.
Fitting temperature sensor
6 Push sensor as far as it will go into the rubber sleeve on the
inspiratory side of the Y-piece. Align the Y-piece so that the
sensor is at the top in order to avoid condensation in the
sensor.
7 Attach the sensor cable with hose clips.
8 Insert the connector for the temperature sensor into the
socket »Temp « at the rear of EvitaXL.
Preparing for use
Ventilating adults and children
Instructions for Use EvitaXL 27
5
4
6
0.6m
0.6m
3
0.6m
0.4m
1
7
D
0.4m
8
2
Evita XL
079
072
080