EvitaXL

Preparing for use
Fitting O2 sensor capsule
Fitting O2 sensor capsule
— when using the system for the first time
— when the display reads:
O2 measurement inop
— when calibration can no longer be performed
● Ensure device is in standby or ventilator is switched off.
● Tilt the control unit upwards, pressing the segments on the
right and left at the same time.
1 Turn the inspiratory port to the left.
2 Use coin to loosen screw, and remove protective cover.
3 Loosen the two knurled screws and open the sensor
housing.
4 Remove old sensor capsule and fit a new capsule. The end
with the circular tracks remains visible.
3 Close the sensor housing securely with the two knurled
screws.
2 Screw protective cover back in place.
● Dispose of the used O2 sensor capsule, page 168.
24 Instructions for Use EvitaXL
1
4
3
2
071