EvitaXL

Preparing for use
Positioning the control unit
Preparing for use
● Always use properly prepared parts, see "Preparing",
page 155.
● Hospital infection control regulations must be observed.
Positioning the control unit
● The control unit must not be stood up or leant against anything,
nor may it be laid face downwards! It must always be
laid on its back when changing over.
Positioning on the EvitaXL
● Hook the control unit into the mount on EvitaXL until it
engages.
To adjust the position:
1 Press and hold the segments on the right and left, at the
same time tilting the control unit into the required position.
Positioning on the wall rail
2 Press and hold the segments on the right and left, tilting the
control unit down completely at the same time.
3 Press and hold the unlocking buttons on the right and left,
lifting the control unit out of the mount on EvitaXL at the
same time.
● Unwind the required length of cable.
● Hook the control unit into the wall rail and
22 Instructions for Use EvitaXL
1
2
3
170
091
092