Bentley Volkswagen.Golf.Jetta.R32.Official.Factory.Repair.Manual.1999-2005

Cylinder head, servicing
Página 45 de 58
15-38
The camshaft bar T10068 must
engage in both shaft grooves.
If the camshaft bar will not fit:
- Turn crankshaft one full turn
further in engine direction of
rotation.
Note:
If the camshaft bar cannot be
installed, turn the crankshaft in
engine direction of rotation until
approx. 5 mm past the TDC setting
for No. 1 cyl. (dependent on drive
chain tolerances).
Check setting marks of camshaft
timing adjusters with marks on
control housing:
Marks -A and B- on camshaft
timing adjusters must align with
notches (arrows) on control
housing -C-.
Distance between tooth -1- and
tooth -2- of camshaft timing
adjuster must be exactly 16
rollers of camshaft roller chain.
Note:
Illustration shows a cover which has
been removed.
If the marks do not align:
- Adjust valve timing Page 15-
39 .
If the marks align:
- Install cylinder head cover and
intake manifold Page 15-16 ;
Removing and installing cylinder
head.
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
12/2/2005