Bentley Volkswagen.Golf.Jetta.R32.Official.Factory.Repair.Manual.1999-2005

Sunroof
Página 2 de 4
ignition is switched on/tilted out and closed by pressing and
pulling.
After switching off ignition, slide/tile sunroof can still be
opened and closed as long until drivers or passengers door
is opened.
On rotary switch, there are markings for preset tilt positions
of glass panel. However, any other intermediate tilt position
can be selected by turning switch in clockwise direction.
In switch position - 1 - , opening of slide/tile sunroof in socalled
comfort position decreases driving wind noise which
can occur at complete opening in switch position - 2 - .
Tilt-up/closing of sunroof is performed as long as switch is
pressed/pulled or until respective end position of glass
panel is reached.
Sunroof is equipped with a closing force limit in area of
window. When an obstruction is met during closing
sequence, roof opens again by itself.
As of calendar week 32. 1998, a new motor and rotary
switch was introduced. For this change, glass panel is also
tilted up and closed using rotary switch.
In addition, glass panel is closed by pressing rotary switch,
as long as rotary switch remains pressed.
Note:
Motor and switch can only be recognized on new
replacement part numbers and must not be installed with
older versions.
In addition, there is an emergency close function. If there
are problems closing, sunroof can be forced closed by
pressing preselector, which must be located in "Sunroof
closed" position.
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
13/2/2005