14.02.2016 Views

Bentley Volkswagen.Golf.Jetta.R32.Official.Factory.Repair.Manual.1999-2005

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Special components of <strong>Golf</strong> "GTI 337 Edition"/<strong>Jetta</strong> GLI Sport and <strong>Golf</strong> R32<br />

Página 21 de 23<br />

3. Circumference of installed roof<br />

edge spoiler<br />

◦ Spoiler must be placed on rear lid<br />

and circumference covered in tape<br />

4. Primer surface/reside on rear lid<br />

◦ Preparation 66-8, Preparing<br />

bodywork for adhesive<br />

◦ Dimension - a - = 7 mm<br />

◦ Dimension - b - = 10 mm<br />

Preparing bodywork for adhesive<br />

Note:<br />

Residual material acts as a base for new adhesive sealing<br />

material. Keep adhesive surface free of dirt and grease.<br />

Exception: If bonding is not performed immediately after<br />

cutting back, remaining material must be activated using<br />

Activator D 181 801 A1 .<br />

Warning!<br />

Activator must not come into contact with paint -<br />

otherwise paint will be damaged.<br />

Note:<br />

If bodywork is being worked on or is partially replaced, it<br />

must be cleaned and primed again after painting<br />

corresponding area.<br />

Installation notes<br />

Surfaces of components to be primed must be free of dirt.<br />

- Remove adhesive residue using Adhesive removal<br />

solution D 002 000 10 .<br />

- Saturate a cloth with Silicone remover LSE 020 100 A3 .<br />

- Always wipe application area for adhesive bead twice<br />

using saturated cloth and allow to air dry.<br />

http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...<br />

13/2/<strong>2005</strong>

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!