14.02.2016 Views

Bentley Volkswagen.Golf.Jetta.R32.Official.Factory.Repair.Manual.1999-2005

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Compressor bracket, removing and installing<br />

Página 28 de 35<br />

87-165<br />

Clutch plate gap, checking<br />

Determining "Dimension 1"<br />

Determining "Dimension 2"<br />

The allowable gap (0.4...0.8 mm) is<br />

the difference between "Dimension<br />

1" and "Dimension 2".<br />

Notes:<br />

Gap: 0.4...0.6 mm<br />

(0.015...0.023 in)<br />

- Using depth gauge -1-, measure<br />

gap between top of clutch plate -<br />

3- and pulley -2- at three equally<br />

spaced locations (measurement<br />

must not deviate). Note result.<br />

- If compressor is installed in<br />

vehicle, disconnect electrical<br />

connector -4- from vehicle wiring<br />

harness.<br />

- Using a jumper wire, energize the<br />

clutch coil by applying 12V (B+) to<br />

connector -4-. If compressor is<br />

removed from vehicle,<br />

compressor must be grounded.<br />

- With clutch energized, measure<br />

gap between belt pulley -2- and<br />

clutch plate -3- with depth gauge -<br />

1-. Note result.<br />

Gap must be within tolerance<br />

around entire circumference.<br />

If the gap is outside the permitted<br />

tolerance range, remove clutch<br />

plate and adjust gap by adding or<br />

removing shims Page 87-159 ,<br />

key 3 .<br />

http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...<br />

13/2/<strong>2005</strong>

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!