Bentley Volkswagen.Golf.Jetta.R32.Official.Factory.Repair.Manual.1999-2005

Data Bus On Board Diagnostic Interface -J533- ('Gateway') m.y. 2000 through m.y.... Página 7 de 21
01-142
Diagnostic Trouble Code (DTC) table
Notes:
The following table lists all malfunctions, with the corresponding 5 digit code
numbers, that can be recognized by the Data Bus On Board Diagnostic Interface -
J533- and printed out by the VAG 1551 Scan Tool (ST).
If malfunctions do not occur regularly, these are displayed as occurring sporadically
("SP").
DTC codes appear only on print-out.
Before replacing components, check the wiring and connections to these
components as well as ground connections, according to wiring diagram.
When repair has been carried out, the Diagnostic Trouble Code (DTC) memory must
always be erased and checked again with VAG 1551 Scan Tool (ST).
If there is a specific complaint and no malfunctions are recognized after checking
Diagnostic Trouble Code (DTC) memory, carry out "Read measuring value block"
Page 01-151 .
VAG 1551
print out
Possible cause
Possible
effects
Corrective action
01044
Control
Module
incorrectly
coded
A control module
connected to the
power-train CAN Bus
(Data Bus) is incorrectly
coded
Functions of
systems
connected to
CAN-Bus not
OK
- Check DTC memory of
all control modules
connected to CAN-Bus
and repair malfunctions
if necessary
A control module
connected to the
power-train CAN Bus
(Data Bus) is
malfunctioning
- Check control module
coding, correct if
necessary
- Replace control
module if necessary
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
13/2/2005