Bentley Volkswagen.Golf.Jetta.R32.Official.Factory.Repair.Manual.1999-2005

Description of work (part 2 of 2)
Página 53 de 59
or
Headlight setting unit VAS 5047/
The following test- and adjustment instructions are
applicable to all countries. But national legislation and
regulations of the respective country is to be adhered to.
The following are prerequisites when adjusting
headlights with gas discharge system:
Tire pressure OK.
Lenses must not be damaged or dirty.
Reflectors and bulbs OK.
The parking brake must not be engaged and no gear
should be selected.
The steering wheel must be in straight-ahead position.
The vehicle may not be moved during the basic setting
(including door "open and close" , leaning against, getting
in and out).
Nobody may be in the vehicle and the vehicle must not be
loaded.
Move vehicle back and forth for 1 meter (3 to 4 feet) or
bounce front and rear of vehicle several times up and down
to settle suspension.
Vehicle and headlight adjuster must be on a level surface.
Vehicle and headlight adjuster must be aligned.
Inclination must be set.
In the trim above the headlight, inclination measurements
are stamped in "%" . The headlights must be adjusted
according to these measurements. Percentage information
is based on a projection distance of 10 meters. For
example: inclination of 1.2 % converts to approx. 12 cm.
Headlight (left):
Perform basic setting with the Vehicle Diagnosis, Testing
and Information System VAS 5051B :
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
13/2/2005