Views
5 years ago

vero uk training material - VCAM TECH Co., Ltd

vero uk training material - VCAM TECH Co., Ltd

Inserting the Angle Pin

Inserting the Angle Pin VISI Mould - Slide Assembly Creation The final part of the Slider Assembly will be the insertion of the Angle Pin used for actuating the slide. Firstly, activate the layers shown opposite. Activate the Layers as shown here. You should only need to append the CAV layer to the visible list. Select the Hasco Catalogue and the Slider Core menu tab and pick the Z01_L angle pin from the item list. Pick the Z01_L angle pin from the item list. Select the Slider Core tab from the Hasco Catalogue menu. It is now necessary to select a Start plate, the Slide , a Point and the Slide Direction. Pick the Start Plate as shown, this is the Fixed Half Cav plate. Pick the Slide body as shown, this is the slide that the pin will pass through. Vcamtech Co., Ltd 10

VISI Mould - Slide Assembly Creation Now input the Angle Pin insertion co-ordinates. The pin point is actually 10mm from the centre of the front edge of the slide. This actually translates to a tool co-ordinate position as shown below :- Now select the Stroke Direction for the slide. This should be a –Y direction, representing the retraction direction of the slide as the tool opens. Shown Below:- Arrow represents the –Y direction and should point the same way as shown opposite. Insertion point 10mm from centre of front edge of Slide. Absolute ref 0,- 105,90 This is the Initial Preview after you have confirmed the stroke direction. Vcamtech Co., Ltd 11

YT-1200 - YOUNG TECH Co., Ltd.