vero uk training material - VCAM TECH Co., Ltd

VISI Modelling – Draft Analysis
‘Only common faces’ – Faces that are identical (to within the set tolerance) will be
coloured in the ‘common’ colour. Other faces will be coloured first or second colour as
appropriate.
‘Partially common faces’ – The models are coloured the same as ‘Only common faces’
above except, faces that have both identical and different areas will be ‘split’ coloured (i.e.
Common colour and first or second colour as appropriate).
‘External – Internal zones’ – This mode will activate the internal and external colour
selection icons (and disable the basic first and second colour icons). The models will be
coloured with the ‘common’ colour and the areas that are different will be coloured using
the ‘Internal’ or ‘External’ colour depending upon whether the situation is ‘metal on’ or
‘metal missing’
Update the display
The colours for the first
and second models can
be set here
Select the ‘Transparency’
option to activate a slider
bar. Moving the slider bar
will dynamically show both
models
Moving the
transparency slider bar
will display both sets of
faces on either model
Apply
Set the detection
method here
The comparison tolerance is
set here. Differences less than
this will be shown as ‘common’
If ‘Show common
zones’ is set, the
complete model will be
displayed. If this option
is switched off, only the
different faces will be
displayed
Vcamtech Co., Ltd 4