vero uk training material - VCAM TECH Co., Ltd

Adding Lifters to the Design
VISI Mould - Inserting Lifters
Looking at the part closely you can see that there are 4 clip features that cause under cut
conditions in the moulding this will require the use of lifters to mould these features without
trapping the mould.
The circles show 2 of the 4 clips that will
require lifters.
Lets begin to build the first lifter by following the next exercise: -
To make the task of inserting the Lifters into the assembly easier, we will again filter the
layers selecting only the ones relevant for the task.
Select the Layer Group “Lifter Insertion”
to activate the relevant layers.
Make sure UPP is the Current Layer.
Enable the Layers shown above, you can see
that the lifter heads (x4) have already been
modelled (U+A1, U+A2).
Vcamtech Co., Ltd 2