Extron XTP CrossPoint 1600 and 3200 ... - Extron Electronics

SIS Command and Response Table for Output-Endpoint-Specific Commands (continued)
Command Function
SIS Command
(Host to Unit to Endpoint)
Response
(Endpoint to Unit to Host)
Additional description
XTP SR HDMI scaler specific commands (continued)
HDCP status
View output HDCP status E O X@ HDCP } X3$]
View HDCP status of all outputs E O*HDCP } X3$ 1 X3$ 2 X3$ 3 ... X3$ n ]
Relay controls
Turn on an endpoint relay EX@ * X3* *1RELY } RelyX@ * X3* *1 ] Turn on relay X3* in output X@.
Turn off an endpoint relay EX@ * X3* *0RELY } RelyX@ * X3* *0 ] Turn off relay X3* in output X@.
Toggle an endpoint relay EX@ * X3* *2RELY } RelyX@ * X3* * X4)] Toggle (on-to-off or off-to-on) relay X3*
in output X@.
Pulse an endpoint relay EX@ * X3* *3* X3( RELY } RelyX@ * X3* *3 ] Turn on relay X3* in output X@ for an
interval defined as X3(. Each step of
X3( is 16 ms.
Example: E 1*2*3*45RELY } Rely1*2*3] Turn on relay 2 in output endpoint 1 for
720 ms
(0.72 sec, X3( = 45 * 16 ms = 720 ms).
View an endpoint relay status EX@ * X3* RELY } X4)] On or off.
View video and audio mutes
View output mutes E VM } X3& 1 X3& 2 ... X3& n ] Each X3& response is the mute status of
an output, starting from output 1.
n = either 16 or 32.
Example :
(XTP CrossPoint 3200)
E VM } Audio is muted on outputs 2 and 3,
02201000000000000000000003000000] video on output 5, and video and audio
on output 26. All other outputs are
unmuted.
NOTE: X@ = Output number 01 – 16 or 32
X3$ = HDCP status (for outputs) 0, 2, 4, or 6 = No monitor connected
1, 3, or 5 = Monitor connected but the video signal is not encrypted
7 = Monitor connected and the video signal is encrypted
X3& = Video and audio mute status 0 = No mutes 4 = Analog audio mute
1 = Video mute 5 = Video and analog audio mute
2 = Digital audio mute 6 = Digital and analog audio mute
3 = Video and digital audio mute 7 = Video, digital audio, and analog audio mute
X3* = Relay on endpoint 1 or 2
X3( = Pulse duration 0 through 65535 (each step = 16 ms, see the example above)
X4) = Relay status 0 = Off 1 = On
XTP CrossPoint 1600 and 3200 Switchers • Programming Guide 102