Extron XTP CrossPoint 1600 and 3200 ... - Extron Electronics
Extron XTP CrossPoint 1600 and 3200 ... - Extron Electronics
Extron XTP CrossPoint 1600 and 3200 ... - Extron Electronics
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Host-to-Switcher Instructions<br />
Switcher-initiated Messages<br />
The switcher accepts SIS (Simple Instruction Set) comm<strong>and</strong>s through the rear panel<br />
Remote RS-232 / RS-422 port, the front panel Configuration port, <strong>and</strong> the rear panel<br />
Ethernet (LAN) Port. SIS comm<strong>and</strong>s consist of one or more characters per comm<strong>and</strong><br />
field. They do not require any special characters to begin or end the comm<strong>and</strong> character<br />
sequence. Each switcher response to an SIS comm<strong>and</strong> ends with a carriage return <strong>and</strong> a<br />
line feed (CR/LF = ]), which signals the end of the response character string. A string is<br />
one or more characters.<br />
When a local event such as a front panel operation occurs, the switcher responds<br />
by sending a message to the host. The switcher-initiated messages are listed below<br />
(underlined).<br />
The switcher does not expect a response from the host, but, for example, the host program<br />
might request a new status.<br />
(c) Copyright 20yy, <strong>Extron</strong> <strong>Electronics</strong> <strong>XTP</strong> CP nn00, Vx.xx,<br />
60-nnnn-01 {day, date, time}]<br />
The switcher initiates the Copyright message when it is first powered on or when a<br />
connection via Internet protocol (IP) is established. Vx.xx is the firmware version number<br />
<strong>and</strong> 60-nnnn-01 is the switcher part number.<br />
NOTE: {day, date, time} are reported only if the connection is via the LAN port.<br />
Password:]<br />
The switcher initiates the Password message immediately after the copyright message<br />
when the controlling system is connected using TCP/IP or Telnet <strong>and</strong> the switcher is<br />
password protected. This message means that the switcher requires an administrator or<br />
user level password before it will perform the comm<strong>and</strong>s entered via this link. The switcher<br />
repeats the password message response for every entry other than a valid password until a<br />
valid password is entered.<br />
]Login Administrator]<br />
]Login User]<br />
The switcher initiates the Login message when a correct administrator or user password<br />
has been entered. If the user <strong>and</strong> administrator passwords are the same, the switcher<br />
defaults to administrator privileges.<br />
Qik]<br />
The switcher initiates the Qik message when a front panel tie creation has occurred.<br />
Sprnn]<br />
The switcher initiates the Spr message when a memory preset has been saved from the<br />
front panel. “nn” is the preset number.<br />
Rprnn]<br />
The switcher initiates the Rpr message when a memory preset has been recalled from the<br />
front panel. “nn” is the preset number.<br />
Innn•Audxx]<br />
The switcher initiates the Aud message when a front panel input audio level change has<br />
occurred. “n” is the input number <strong>and</strong> “xx” is the dB level.<br />
<strong>XTP</strong> <strong>CrossPoint</strong> <strong>1600</strong> <strong>and</strong> <strong>3200</strong> Switchers • Programming Guide 72