Extron XTP CrossPoint 1600 and 3200 ... - Extron Electronics

6. After verifying that the IP address change was successful, enter and issue the arp –d
command at the Command prompt. For example:
Connecting as a Telnet Client
arp –d 10.13.197.7 removes 10.13.197.7 from the ARP table
or
arp –d* removes all static IP addresses from the ARP table.
The Microsoft Telnet utility is available from the Command prompt. Telnet allows you to input
SIS commands to the XTP CrossPoint switcher from the PC via the Ethernet link and the
LAN.
Access the Command prompt and start Telnet as follows:
1. On the Windows task bar, click Start > Run.
2. At the Open prompt, type command.
3. Click the OK button.
4. At the Command prompt, type Telnet and then press . The computer returns
a display similar to the one shown in figure 75.
Microsoft (R) windows 2000 (TM) Version 5.0 (Build 2195)
Welcome to Microsoft Telnet Client
Telnet Client Build 5.00.99203.1
Escape Character is 'CTRL+]'
Microsoft Telnet>
Figure 75.
Telnet Window
Telnet Tips
It is not the intention of this guide to detail all of the operations and functionality of Telnet;
however, some basic level of understanding is necessary for operating the XTP CrossPoint
switcher via Telnet.
Open
Connect to the XTP CrossPoint switcher using the Open command. Once you are
connected to the switcher, you can enter the SIS commands the same as you would if you
were using the RS-232 of RS-422 link.
Connect to the XTP CrossPoint switcher as follows:
1. At the Telnet prompt, type open {IP address} and then press .
If the switcher is not password protected, no further prompts are displayed until
you break or disconnect the connection to the matrix switcher.
If the switcher is password protected, Telnet displays the password prompt.
XTP CrossPoint 1600 and 3200 Switchers • Ethernet Connection 143