Extron XTP CrossPoint 1600 and 3200 ... - Extron Electronics

SIS Command and Response Table for Input-Board-Specific Commands (continued)
Command Function
SIS Command
(Host to Unit)
Response
(Unit to Host)
Additional description
Inputs on XTP CP 4i VGA (Analog Video) Boards (continued)
Horizontal shift
Specify a value E I X^*X3! HCTR } HctrIX^*X3!] Set the horizontal location of first active
pixel in input X^.
Increment value E I X^–HCTR } HctrIX^*X3!] Increment the value by one pixel (shift
the image to the right).
Decrement value E I X^+HCTR } HctrIX^*X3!] Decrement the value by one pixel (shift
the image to the left).
View E I X^HCTR } X3!] Show the horizontal location of first
active pixel in input X^.
Vertical shift
Specify a value E I X^*X3! VCTR } VctrIX^*X3!] Set the vertical location of first active
pixel in input X^.
Increment value E I X^+VCTR } VctrIX^*X3!] Increment the value by one line (shift up).
Decrement value E I X^–VCTR } VctrIX^*X3!] Decrease the value by one line (shift
down).
View E I X^VCTR } X3!] Show the vertical location of first active
pixel in input X^.
Save and recall analog input presets
NOTES:
• Analog input presets are available for analog (RGB, YUVp, YUVi, S-video, composite) video input signals on an XTP CP 4i VGA
universal analog input board only.
• Analog input presets save a set of analog variables, such as: horizontal and vertical shift, pixel phase, color and tint, brightness
and contrast, input type, and audio input level (gain and attenuation).
Save an analog input preset X^*1*X3@. SprX^*1*X3@] Command character is a period.
Recall an analog input preset X^*1*X3@, RprX^*1*X3@]
NOTE: X^ = Input number (for other than tie) 01 – 16 or 32
X3! = Shift 00000 through 65535
X3@ = Analog input preset 1 through 8
XTP CrossPoint 1600 and 3200 Switchers • Programming Guide 87