Download Adept Cobra PLC600 User's Guide - pulsar.com.tr
Download Adept Cobra PLC600 User's Guide - pulsar.com.tr
Download Adept Cobra PLC600 User's Guide - pulsar.com.tr
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installing Robot Solenoid Kit<br />
Air intake coupling<br />
with spare air line<br />
installed<br />
Tubing connected<br />
to output port<br />
Mounting screws for<br />
solenoid assembly<br />
Figure 7-8. Solenoid Placement Using Mounting Hardware<br />
9. Install the appropriate lengths of 5/32 inch plastic tubing (supplied) into the two<br />
output ports on the manifold. Route the tubing up along the tower bracket next to<br />
the quill and down through the center of the quill. Use tie-wraps as needed to<br />
secure the tubing.<br />
10. Loosen the securing screw on the AIB chassis, and lower the chassis down flat.<br />
See Figure 8-2 on page 119 for the location of the securing screw.<br />
11. Remove the cable s<strong>tr</strong>ap plate by removing two screws and split washers. See<br />
Figure 7-9. This allows the harness to move when you lift the J1 cover in the next<br />
step.<br />
Two M5 x 8 screws<br />
Cable S<strong>tr</strong>ap Plate<br />
Figure 7-9. Removing the Cable S<strong>tr</strong>ap Plate<br />
<s<strong>tr</strong>ong>Adept</s<strong>tr</strong>ong> <s<strong>tr</strong>ong>Cobra</s<strong>tr</strong>ong> <s<strong>tr</strong>ong>PLC600</s<strong>tr</strong>ong>/PLC800 Robot User’s <s<strong>tr</strong>ong>Guide</s<strong>tr</strong>ong>, Rev B 111
Change language