Download Adept Cobra PLC600 User's Guide - pulsar.com.tr

PLC Server Installation
Table Mounting the PLC Server
To table mount the PLC Server, install two brackets on each side near the bottom of the
unit, as shown in Figure 3-5. Use the screws from the accessories kit.
4X 40356-00001
R 3.6
29.5
12.1
24.1
120.9
24.9
378.6
391.8
4X M3 x 6MM
BOTH SIDES
16.2
CompactFlash Memory Card
Figure 3-5. Table Mounting the PLC Server
16.0
120.9
21.6
The PLC Server is equipped with a CompactFlash (CF) memory card. The PLC Server
system uses a CF in place of a traditional hard disk drive. In fact, it is often referred to as a
“solid state hard drive”. The CF is about half the size of a credit card and twice as thick. It
has no moving parts and is therefore reliable and durable.
The CF shipped with all systems has a capacity of 30 MB and is factory configured by
<strong>Adept</strong>. The CF stores the PLC Server software.
NOTE: <strong>Adept</strong> reserves the right to increase the size of the standard CF
without notice.
Not all types of CompactFlash are <strong>com</strong>patible with the PLC Server. <strong>Adept</strong> requires the use
of the CF supplied by <strong>Adept</strong> at the time of the PLC Server purchase and that all
replacement CF cards be obtained from <strong>Adept</strong>.
CAUTION: Use suitable measures for eliminating
electrostatic discharge during handling of the
CompactFlash. This includes, but is not limited to, the use
of a grounded wrist strap while performing this operation.
<strong>Adept</strong> <strong>Cobra</strong> <strong>PLC600</strong>/PLC800 Robot User’s <strong>Guide</strong>, Rev B 41