MX-M264N/M314N/M354N Operation-Manual GB

COPIER
ADDING A WATERMARK TO A COPY (Watermark)
This function requires the hard disk drive.
When making a copy, specific text can be added to the copy as a watermark. The density, angle, and pages (first page
only or all pages) can be selected for a watermark. The watermark is printed at the centre of the paper.
Printing "CONFIDENTIAL" on the paper
CONFIDENTIAL
The following 12 selections are available for the stamp text.
CONFIDENTIAL PRIORITY PRELIMINARY FINAL
FOR YOUR INFO. DO NOT COPY IMPORTANT COPY
URGENT DRAFT TOP SECRET PLEASE REPLY
Three levels can be selected for the density of the watermark.
The angle of a watermark can be selected in the range +90 degrees to -90 degrees in increments of 45 degrees.
1
Touch the [Watermark] key in the stamp selection screen.
See steps 1 to 4 of "GENERAL PROCEDURE FOR USING STAMP" (page 2-81).
Stamp
Watermark
Cancel
OK
Touch the key of the watermark that you
wish to use.
2
CONFIDENTIAL
FOR YOUR INFO.
URGENT
PRELIMINARY
IMPORTANT
PRIORITY
DO NOT COPY
DRAFT
FINAL
COPY
Exposure
1 2 3
Angle
(+90 -90)
45
First Page
All Pages
TOP SECRET
PLEASE REPLY
Stamp
Watermark
Cancel
OK
Touch the [Exposure] key and set the
colour and density.
3
CONFIDENTIAL
FOR YOUR INFO.
URGENT
PRELIMINARY
IMPORTANT
PRIORITY
DO NOT COPY
DRAFT
FINAL
COPY
Exposure
1 2 3
Angle
(+90 -90)
45
First Page
All Pages
If you wish to darken the exposure, touch the key. If you
wish to lighten the exposure, touch the key.
When you have finished selecting the settings, touch the [OK]
key.
TOP SECRET
PLEASE REPLY
2-98
Contents