MX-M264N/M314N/M354N Operation-Manual GB

SCANNER/INTERNET FAX
(1) (A)
(B)
(2)
Specify the original size.
Scan/Special Modes
OK
(1) Enter the original size.
4
Card Shot
X
Y
86
54
Y
(25~210)
mm
(25~210)
mm
Cancel
Fit to
Send Size
Size Reset
OK
• Touch the X (width) numeric value display key and
enter the width.
• Touch the Y (height) numeric value display key and
enter the height.
(A) To return the original size to the default size, touch the
[Size Reset] key.
(B) To automatically enlarge or reduce the image to fit the
send size, touch the [Fit to Send Size] key. If you wish
to scan the original at the entered original size, there
is no need to touch this key.
(2) Touch the [OK] key.
X
• You can also touch the keys to change the number.
• The send size will be selected automatically based on the entered original size.
• After selecting Card Shot, you can touch the [Original] key in the base screen to change the original scan size or the
send size. In this case, the screen of this step appears when you touch the scan size key. For the procedure for
setting the send size, see "Specifying the send size of the image" (page 5-59).
5
Press the [START] key to scan the front side of the card.
To cancel scanning...
Press the [STOP] key (
) to cancel the operation.
6
Turn the card over and press the [START] key to scan the reverse side of the
card.
Press the same [START] key that was used to scan the front side.
Before scanning the back of the card, you can touch the [Configure] key in the touch panel to change the exposure.
To cancel scanning...
Press the [STOP] key (
) to cancel the operation.
5-84
Contents