MX-M264N/M314N/M354N Operation-Manual GB

SCANNER/INTERNET FAX
CHANGING THE SUBJECT, FILE NAME, AND BODY
TEXT
The subject, file name, and body text can be changed when performing an Internet fax transmission. Preset items can
be selected or text can be directly entered.
To change the body text, the hard disk drive is required.
• If the subject and file name are not changed, the settings in the Web page are used.
• Selections for the subject, file name, and body text are configured by clicking [Application Settings] and then [Network
Scanner Settings] in the Web page menu.
• For the procedure for entering text, see "ENTERING TEXT" (page 1-55) in "1. BEFORE USING THE MACHINE".
1
Touch the [Send Settings] key in the base screen.
BASE SCREEN (page 5-9)
Send Settings
Subject
OK
To change the subject, touch the
[Subject] key.
2
File Name
Body Text
(1)
(2)
Enter the subject.
Subject
Cancel
OK
(1) Touch a pre-set text key.
Direct Entry
(2) Touch the [OK] key.
No.01 Sub: Schedule coordination
No.02 Sub: Monthly Schedule
No.03 Sub: Minutes of planning m
No.05
No.04
No.06
1
5
3
No.07
No.09
No.11
No.08
No.10
No.12
• If you wish to directly enter the text, touch the [Direct Entry] key to open the text entry screen. Enter the text and
touch the [OK] key.
• The text in a pre-set text key can be edited by touching the pre-set text key and then the [Direct Entry] key. The text
entry screen will appear with the selected pre-set text entered. (When a destination is stored using the Web page,
up to 80 characters can be entered. However, only 54 characters can be entered in the touch panel.)
5-44
Contents