MX-M264N/M314N/M354N Operation-Manual GB

SCANNER/INTERNET FAX
(1)
(2)
Select job build mode.
Scan/Special Modes
OK
(1) Touch the [Job Build] key so that it is
highlighted.
4
Program
Timer
Erase
Suppress
Background
Dual Page
Scan
Card Shot
1
2
(2) Touch the [OK] key.
Job
Build
Mixed Size
Original
Slow Scan
Mode
Original
Count
File
Quick File
5
6
Press the [START] key to scan the first set of originals.
To cancel scanning...
Press the [STOP] key (
) to cancel the operation.
Insert the next set of originals and press the [START] key.
Repeat until all originals have been scanned.
To cancel scanning...
Press the [STOP] key (
) to cancel the operation. All scanned data will be cleared.
Place next original. (Pg.No.x)
Press [Start].
When finished, press [Read-End].
Touch the [Read-End] key.
7
Configure
Read-End
• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
• The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original
page scanned. However, when Job Build is used in combination with "2in1" in the special modes, only the exposure
can be changed when scanning each even-numbered page of the original pages.
If the memory becomes full during scanning, a message will appear and the transmission will be cancelled.
To cancel the job build function...
Touch the [Job Build] key in the screen of step 4 so that it is not highlighted.
5-87
Contents