MX-M264N/M314N/M354N Operation-Manual GB

SCANNER/INTERNET FAX
CHANGING THE PRINT SETTINGS FOR THE
TRANSACTION REPORT
(Transaction Report)
A transaction report is automatically printed out to alert you when an Internet fax transmission fails or when a broadcast
transmission is performed. The transaction report contains a description of the transmission (date, start time, name of
other party, time required, number of pages, result, etc.).
INFORMATION APPEARING IN THE RESULT COLUMN (page 5-111)
This function cannot be used in scan mode, USB memory mode, or data entry mode.
Transaction reports are printed based on conditions set in the system settings; however, you can temporarily select
different conditions for a transmission. To change the transaction report print conditions at the time of transmission,
follow the steps below.
1
2
3
Place the original.
Place the original face up in the document feeder tray, or face down on the document glass.
Specify the destination.
ENTERING DESTINATIONS (page 5-18)
Select the special modes.
(1) Touch the [Internet Fax] tab.
(2) Touch the [Special Modes] key.
(3) Touch the keys to switch through the screens.
(4) Touch the [Transaction Report] key.
SPECIAL MODES (page 5-71)
Internet Fax/Special Modes
Transaction Report
(1) (2)
OK
Cancel
OK
Select print conditions.
(1) Select the print conditions.
(2) Touch the [OK] key.
Always Print Print at Error Do not Print
4
Print Original Image
• The print conditions for a transaction report are as follows:
"Always Print": A transaction report is printed no matter whether the transmission succeeds or fails.
"Print at Error": A transaction report is printed when transmission fails.
"Do not Print": Do not print a transaction report.
• When the [Print Original Image] checkbox is selected , part of the transmitted original is included on the
transaction report.
5-101
Contents