MX-M264N/M314N/M354N Operation-Manual GB

TROUBLESHOOTING
Problem Point to check Solution
Part of the image is
cut off.
Printing takes place
on the wrong side of
the paper.
A cover or insert is not
printed on the
specified paper.
Has the correct paper size been set?
Was the original placed in the correct
position?
Is the paper loaded with the print side
facing in the correct direction?
Has the paper type been set correctly?
If you are using a special size, be sure to specify the
paper size.
If the size of paper loaded in a tray was changed, be
sure to check the paper size setting.
System Settings > "Paper Tray Settings" > "Tray
Settings"
If you are using the document glass, be sure to
place the original in the far left corner of the
document glass.
1. BEFORE USING THE MACHINE "PLACING
THE ORIGINAL ON THE DOCUMENT GLASS"
(page 1-38)
Check that the paper is loaded so that printing takes
place on the correct side.
• Trays 1 to 4:
Load the paper with the front side facing up*.
• Bypass tray and tray 5:
Load the paper with the front side facing up*.
* When the paper type is "Pre-Printed" or "Letter
Head", load the paper in the opposite way. (Except
when "Disabling of Duplex" is enabled in the system
settings (administrator). For the current setting, check
with your administrator.)
Set the correct paper type for the tray that contains
the paper specified for the cover or insert.
If the paper type set for the cover or insert is not the
same as the paper type set for the tray, paper will be fed
from a different tray.
System Settings > "Paper Tray Settings" > "Tray
Settings"
8-44
Contents