MX-M264N/M314N/M354N Operation-Manual GB

FACSIMILE
CHECKING THE IMAGE BEFORE
FORWARDING
This function requires the hard disk drive.
When "Received Data Image Check Setting" is enabledin the system settings (administrator), you can select the
received data from the list and forward it to the addresses recorded in the address book. When this function is enabled,
follow the steps below to forward the received image.
* The factory default setting is disabled.
Depending on the size of the received data, part of the image in the image check screen on the touch panel may not appear.
1
The memory has received data.
Check the data?
No
Yes
When an image is received, a
confirmation prompt will appear. Touch
the [Yes] key.
If this message appears while you are configuring settings of
any type and you touch the [Yes] key, the settings that you are
configuring will be cancelled. If this message appears in
another mode, you will return to the base screen of image send
mode after checking the image.
(1)
Select the received image
Received Data List
Thumbnail
Back
Select All
(1) Touch the key of the received image that
you want to check.
0123456789
04/04/2012
10:28
Not checked
Multiple received images can be checked.
2
BBB BBB
9876543210
BBB 0612345678 BBB
BBB 0123456789 BBB
CCC CCC
Image Check
Forward
04/04/2012 10:14
04/04/2012 10:12
04/04/2012 10:08
04/04/2012 10:00
04/04/2012 10:00
Delete
Checked
Not checked
Checked
Not checked
Checked
Print
1
5
(2) Touch the [Forward] key.
• To show thumbnails of the received images, touch the
[Thumbnail] key.
• To check a receieved image, touch the [Image Check]
key.
IMAGE CHECK SCREEN (Page 4-65)
(2)
5 10 15
Address Review
To
AAA AAA
CCC CCC
Cc
BBB BBB 1
2
DDD DDD
Touch the Forward Destination from the
address book to select it.
Multiple forwarding addresses can be checked.
3
EEE EEE
GGG GGG
FFF FFF
HHH HHH
III III
JJJ JJJ
Freq. ABCD EFGH IJKL MNOP QRSTU VWXYZ etc.
Sort Address
Start forward.
4-64
Contents