MX-M264N/M314N/M354N Operation-Manual GB

SYSTEM SETTINGS
Disabling of Stapler* 4 Disabled 7-69
Fusing Control Settings 60 - 89g/m 2 (16 - 23 lbs.) 7-69
Plasmacluster Settings 7-69
Plasmacluster Operation at Powering On of Machine ON, Airflow: Low 7-69
Plasmacluster Operation at Powering Off of Machine ON, Turn off Immediately 7-69
Status Indicator Setting Pattern 1 7-69
*1 When the hard disk drive is installed.
*2 When the automatic document feeder is installed.
*3 When a paper drawer is installed.
*4 When a finisher is installed.
Item Factory default setting Page
Copy Function Settings
Item Factory default setting Page
Copy Function Settings 7-70
Initial Status Settings
Colour Mode
Paper Tray
Exposure Type
Full Colour
Varies depending on the machine
configuration
Auto
7-70
Copy Ratio 100%
2-Sided Copy
1-Side to 1-Side
Output –
Other Settings 7-71
Copy Exposure Adjustment 7-71
Rotation Copy Setting Enabled 7-71
Add or Change Extra Preset Ratios – 7-71
Setting a Maximum Number of Copies 999 7-71
Initial Margin Shift Setting
Side 1 10 mm (1/2")
7-71
Side 2 10 mm (1/2")
Erase Width Adjustment
Edge Clearance Width 10 mm (1/2")
7-71
Centre Clearance Width 10 mm (1/2")
Card Shot Settings
Original Size X: 86 mm (3-3/8"), Y: 54 mm (2-1/8")
7-71
Fit to Page
Disabled
Initial Tab Copy Setting 10 mm (1/2") 7-71
Disabling Deletion of Job Programs Disabled 7-72
7-34
Contents